Why 1×10⁻⁷ cm/s? The Story Behind the Clay Liner Standard
Where the familiar hydraulic conductivity limit for compacted clay liners comes from, and what it does and does not guarantee.
A liner is the engineered floor of a landfill or impoundment. Its job is to keep leachate inside, where it can be collected and treated, and out of groundwater.
A composite liner places a geomembrane in intimate contact with a low-permeability soil or GCL. Each component covers the other’s weakness: the soil limits flow through the inevitable small holes in the geomembrane, and the geomembrane limits the area of soil exposed to leachate. Leakage through a well-built composite liner is typically orders of magnitude lower than through either component alone.
US federal rules for municipal solid waste landfills (40 CFR 258.40) set the default design as a composite liner with an upper geomembrane at least 30 mil thick (60 mil if HDPE) over at least 2 ft of compacted soil with hydraulic conductivity no greater than 1×10−7 cm/s, and a leachate collection system that keeps the head on the liner below 30 cm. The coal combustion residuals (CCR) rule at 40 CFR 257.70 uses a similar composite liner for new CCR units. See coal ash disposal.
A double liner adds a second liner beneath the first, separated by a leak detection drainage layer. Liquid that reaches the leak detection layer is a direct, measurable sign of primary liner leakage, and it is collected before it can reach the secondary liner. Hazardous waste landfills and some state programs, such as Florida’s for certain facilities, require double liners. Whether a given double liner is “equivalent” to a single composite liner depends on the components and is usually judged by comparing leakage and contaminant mass transport.
| Liner | Main strength | Main vulnerability |
|---|---|---|
| Compacted clay | Thick and self-healing; attenuates contaminants by sorption | Desiccation cracking, freeze–thaw, construction variability |
| Geomembrane alone | Near-zero advective flow through intact sheet | Holes, seam defects, wrinkles; organic diffusion |
| GCL | Thin, fast to install, low hydraulic conductivity | Chemical incompatibility, panel shrinkage, low confining stress |
| Composite | Very low leakage when in good contact | Wrinkles break contact; still needs quality assurance |
| Double with leak detection | Redundancy plus measurable leakage | Cost, complexity, slope stability at interfaces |
For a circular hole in a geomembrane over a low-permeability soil, a widely used empirical relation (Giroud, 1997) is
Q = C · [1 + 0.1 (h/ts)0.95] · a0.1 · h0.9 · ks0.74
where Q is the leakage rate (m³/s), h the head on the liner (m), ts the soil thickness (m), a the hole area (m²), ks the soil hydraulic conductivity (m/s), and C ≈ 0.21 for good contact or 1.15 for poor contact. The equation is empirical and must be used in SI units. Its main lesson is practical: keeping the head low and the contact intimate matters as much as the soil’s conductivity.
Where the familiar hydraulic conductivity limit for compacted clay liners comes from, and what it does and does not guarantee.
PFAS show up in nearly all landfill leachate. Here is how containment, collection and treatment fit together.
Seven questions to ask before relying on a geosynthetic clay liner with a non-municipal leachate.